Degradation and mineralization of Bisphenol A (BPA) in aqueous solution using advanced oxidation processes: UV/H 2 O 2 and UV/S2O82− oxidation systems

This work reports on the removal and mineralization of an endocrine disrupting chemical, Bisphenol A (BPA) at a concentration of 0.22 mM in aqueous solution using inorganic oxidants (hydrogen peroxide, H 2 O 2 and sodium persulfate, Na2S2O8;S2O82− ) under UV irradiation at a wavelength of 254 nm and 40 W power (I o  = 1.26 × 10 −6  E s −1 ) at its natural pH and a temperature of 29 ± 3 °C. With an optimum persulfate concentration of 1.26 mM, the UV/S2O82− process resulted in ∼95% BPA removal after 240 min of irradiation. The optimum BPA removal was found to be ∼85% with a H 2 O 2 concentration of 11.76 mM. At higher concentrations, either of the oxidants showed an adverse effect because of the quenching of the hydroxyl or sulfate radicals in the BPA solution. The sulfate-based oxidation process could be used over a wider initial pH range of 3–12, but the hydroxyl radical-based oxidation of BPA should be carried out in the acidic pH range only. The water matrix components (bicarbonate, chloride and humic acid) showed higher scavenging effect in hydroxyl radical-based oxidation than that in the sulfate radical-based oxidation of BPA. UV/S2O82− oxidation system utilized less energy (307 kWh/m 3 ) EE/O in comparison to UV/H 2 O 2 system (509 kWh/m 3 ) under optimum operating conditions. The cost of UV irradiation far outweighed the cost of the oxidants in the process. However, the total cost of treatment of persulfate-based system was much lower than that of H 2 O 2 -based oxidation system.