Anomalous microstructure and tribological evaluation of AlCrFeNiW 0.2 Ti 0.5 high-entropy alloy coating manufactured by laser cladding in seawater

To evaluate the potential of high entropy alloys for marine applications, a new high entropy alloy coating of AlCrFeNiW 0.2 Ti 0.5 was designed and produced on Q235 steel via laser cladding. The microstructure, microhardness and tribological performances sliding against YG6 cemented carbide, GCr15 steel and Si 3 N 4 ceramic in seawater were studied in detail. The AlCrFeNiW 0.2 Ti 0.5 coating showed an anomalous ‘sunflower-like’ morphology and consisted of BCC and ordered B2 phases. The microhardness was approximately 692.5 HV, which was 5 times higher than substrate. The coating showed more excellent tribological performances than Q235 steel and SUS304, a typical material used in seawater environment, sliding against all three coupled balls in seawater. Besides, the wear and friction of AlCrFeNiW 0.2 Ti 0.5 coating sliding against YG6 in seawater were most mild. The main reason was the generation of Mg(OH) 2, CaCO 3, metal oxides and hydroxides and the formation of protective tribo-film on the worn surface of AlCrFeNiW 0.2 Ti 0.5 coating in the process of reciprocated sliding. This would effectively hinder the direct contact between the worn surfaces of AlCrFeNiW 0.2 Ti 0.5 coating and YG6 ball, resulting in a decrease of friction coefficient and wear rate. Thus the YG6 was an ideal coupled material for AlCrFeNiW 0.2 Ti 0.5 coating in seawater, and the coating would become a promising wear-resisting material in ocean environment.