Thermal characterization methodology for thin bond-line interfaces with high conductive materials

Silver sintering offers a promising landscape for Pb-free die attachment in electronics packaging. However, the sintered interface properties are highly process-dependent and deviate from bulk silver properties. Conventional measurement methods do not adequately capture the die-attach application geometry. Hence, this study introduces a novel methodology for characterizing thin bond-line interfaces with high-conductive materials. The transient heat flux impedance ΔZth (t, Δ x) was measured between two thermally sensitive devices interconnected using pressureless Ag-sintering material. A correction factor was derived, based on thermal half-space principles, to account for non-uniform heat spreading over the die-attach interface. Experimental findings estimate an effective conductivity of ∼ 115W/mk for the pressureless Ag-sintered interface. The measurement results were validated by measuring a SAC305 soldered interface, which exhibited ∼ 55 W/mK, and a non-conductive epoxy interface of ∼ 2.5 W/mK. Voids on the die-attach layer, resulting from material processing, were identified to influence the interface thermal behavior. An uncertainty analysis was further discussed, emphasizing equipment tolerances, measurement sensitivity, and geometrical and thermal anisotropies. The article concludes with a comparative summary of the proposed methodology against conventional methods, highlighting differences in working principle, thickness range, measurement parameters, and their advantages and limitations.