On improving the method of electron-beam deposition

The paper deals with improvement of the electron-beam additive forming of metal products using a vertically fed filler wire in vacuum with two electron beams as a heating source. We compared the importance of the power of the heat source required for fusing the layers with each other and the calculated power of the heat source required to melt the filler wire and the surface of the product. Within the experimental conditions of the multilayer electron beam deposition using side wire feeding, the electron beam power of 2.4 kW was required to ensure fusion without the defect formation between the layers during the deposition of Ti-6Al-4V titanium alloy. At the same time, approximate calculations of the minimum power of the heat source required to melt the filler wire and the surface of the product showed a level of 730 W.